Hand-wrapped · Cue service · Made to order
Precision in
every rotation.
Custom rod building, thread work and cue repair. Fishing rods are built from the bare blank through to a finished rod, wraps are drawn for the handle they live on, and cues come in for tips, tenons and ferrules, shaft cleaning and a fresh polish. Everything is tensioned by hand, packed strand by strand and sealed so it survives weather, chalk and time.
- 60 TPI minimum
- Marine-grade epoxy
- Made to order

At the bench
Hand tensioned · sealed gloss

The bench
Beauty that earns its place in your hand.
A wrap is not a sticker. It is the part of the handle your hand actually meets, so the pattern has to work as hard as it looks. Dense wraps shed water faster. Open wraps let the blank load deeper. Both change where a rod, cue or blade sits in your grip.
- Surface prep first. Nothing is wrapped over an unknown substrate.
- Tension re-checked at every pass, not just the first.
- Epoxy laid thin enough that the texture survives the finish.
Three disciplines, one tension
Whatever the handle is attached to.
01Pool cues
Linen and leather wraps matched to the joint ring, plus new tips, tenons and ferrules, shaft cleaning and a fresh polish on cues played every week.
Cue work
02Fishing rods
Full builds, not just wraps: from a bare blank to a finished rod, with grips, reel seat, guides and decorative bands that hold up to salt, sun and a hundred casts.
Rod building
03Samurai handles
Traditional diamond tsuka-ito, tensioned over samegawa, with the menuki kept seated where it belongs.
Tsuka workHow a commission runs
Three stages, no surprises.
- 01
Consult
We look at the actual handle, talk through thread weight and colourway, and sketch the pattern before anything is ordered.
- 02
Wrap
Surface prepped, wrap laid dry, then tensioned pass by pass and packed so the pattern stays even along its full length.
- 03
Finish
Thin epoxy coats, cured and hand-checked. You get it back reading like a different instrument in the hand.

Nicky, the bench
The maker
One pair of hands,
start to finish.
I'm Nicky. I build fishing rods from the bare blank to the finished rod, wrap sword handles, and I take the cue work as well: tips, tenons and ferrules, shaft cleaning, fresh polish and the wraps themselves. All of it out of a one-man shop, along with the pieces other shops pass on. An heirloom that needs saving, a pattern you drew on a napkin, a grip nobody else will touch. The thread is the last thing to go on and the first thing your hand meets, so it gets built like the piece depends on it.
Nothing leaves the bench until the tension feels right in my own hands.
- Pattern, palette and thread count, drawn with you, not picked from a catalogue.
- One of one, every time. No two handles carry the same wrap.
- Cue service too: new tips, tenons and ferrules, shaft cleaning, a fresh polish.
- Restorations welcome: worn ito, tired grips and heirloom blanks.
At the bench
Book time with the wrapper.
One session, one purpose: sit down with the threads, sketches and colour chips and settle the design before anything is wrapped. By appointment.
One-off work
Have a pattern in mind that nobody sells yet?
Send the handle, or send a photo of it with the story behind it. You will get a drawing, a colour card and a firm price before a single thread is cut.




